1. Small blocks only allowed. Stock engine, stock casting heads & block only, single carb only, no roller cams.
2. Must pull 15" at 800 RPM at base of carb.
3. Open headers allowed.
4. If officials don’t believe you vehicle will meet the vacuum rule, stock vacuum will be checked.
5. Tires must be DOT approved. Tire maximum height is 35", mo limit on width.
6. Hitch height maximum 30". All hitches will be checked before pulling.
7. Hitch must be at least 42" from the center of the rear end. All hitches must be stationary, but adjustable in height. Must be solid and cannot pivot. Hitch must come straight out and hook point must be at top of hitch.
8. All trucks must have brakes.
9. Vehicle must be in neutral or park while being hooked and unhooked. No revving of motors.
10. Rear end can be blocked, can be removable or solid.
11. No extra rear end bracing.
12. No transfer cases and no dual wheels.
13. Puller must stop vehicle immediately upon signal from track officials and or red light.
14. Any vehicle that doesn’t exceed the 50' mark can restart.
15. Classes will be 2WD 5500 & 6000Lb. If you can’t meet the weight limit you can’t enter.
16. Any weight and or equipment lost off truck while hooked to the sled will mean DISQUALIFICATION. 17. Weights may be past the front bumper but no further than 15ft. Of the center of the rear axle. No weights are to be past the tail gate.
18. NO PASSENGERS (DRIVERS ONLY) NO EXCEPTIONS.
19. After weigh in, pull into line up area by sled, be ready to pull when called.
20. HOOD IS REQUIRED.
21. No opening of hoods after weigh in.
22. No adding weights after weigh in, moving weights around is allowed.
23. Must have working kill switch.
24.If you are 1st puller and you pull out of bounds you do not get the option of a repull, also if you are 1st puller and want to take advantage of your repull option you must tell the officials immediately following your pull you cannot wait for others to pull before stating you want to repull.