2007 Rules: 6200 Lb Stock 4x4
     
Moody Sled Team - Formerly J&L Sled Team

Moody Sled Team's Photo Page 1

Moody Sled Team's Photo Page 2

2006 Points

2007 Points

2008 Points

2007 J & L Sled Team General Rules & Regulations

2007 Rules: 1500 Lb Mini Rods

2007 Rules: 1800 Lb Mini Rods

2007 Rules: 1800 Lb Boost Mini Rods

2007 Rules: 2900 Lb Mini Trucks

2007 Rules: 6000 Lb Stock 2WD

2007 Rules: 6000 Lb Modified 2WD

2007 Rules: 6200 Lb Stock 4x4

2007 Rules: 6200 Lb Pro Street

2007 Rules: HomeTown Gas Class (NO DIESELS!!)

WHAT'S NEW PAGE -GAMES-

Contact Page

Guest Book

~ Our Favorite Sites ~

 
6200 LB Stock 4X4

 

1. 472 CU. IN. Limit on big blocks only. Stock engines only, cast block and heads only. Single carb only.

2. Must pull 17" of vacuum at 800 RPM at the base of carb.

3. If officials don’t believe your vehicle will meet the vacuum rule, stock vacuum will be checked.

4. Can run open headers but has to be behind the cab of the truck.

5. Tires must be DOT approved. Tire maximum height is 35", no limit on width.

6. Hitch height is 26" maximum. All hitches will be checked before pulling.

7. Hitch must be at least 42" from center of rear end. Must be stationary, but adjustable in height. Must be solid, flat and cannot pivot.

8. All must run together.

9. All trucks must have working brakes.

10. Vehicle must be in neutral or park while being hooked and unhooked. No revving motors.

11. Rearend can be blocked, can be solid or removable.

12. No dual wheels.

13. Puller must stop vehicle immediately upon signal from track officials and or red light.

14. Any vehicle that doesn’t exceed the 50' mark can restart.

15. Classes will be 4x4 6200 LB. If you can’t meet the weight limit you can’t enter.

16. Any weights and or equipment lost off truck while hooked to the sled will mean DISQUALIFICATION.

17. No weights in front of the bumper.

18. NO PASSENGERS (DRIVERS ONLY) NO EXCEPTIONS.

19. After weigh in pull into line up area by sled and be ready to pull when called.

20. HOOD IS REQUIRED. No opening of hoods after weigh in. No adding weight, moving weight around is allowed.

21. Must have one loop on each end of drive shaft (must have 2 rings).

22. MUST HAVE WORKING KILL SWITCH.

23.If you are 1st puller and you pull out of bounds you do not get the option of a repull, also if you are 1st puller and you want to take advantage of your repull option you must tell the officials immediately following your pull you cannot wait for others to pull before stating you want to repull.




Links to Other Sites
My Links

 
   
 

All Rights Reserved

Website Designed by Moody Sled Team

Copyright © 2007 & 2008 Moody Sled Team